This is my parametric box with a spring loaded lock!

This parametric box gives you perfect control over the desired dimensions for your project! You can change the length, width, heigth and corner radii. Wheter you want to store something tiny or securely store a larger object, here is your solution! The minimalist design allows you to make further changes! For example, add fuzzy skin to the lid or deboss a special pattern or even your name on the lid.

Features:

• fully customizable length, width, heigth and radii
• pattern in the lower part: adjust the angle of the debossing between 45° an 90°
• non- printed parts: only one spring is needed!
• no supports needed!
• clean 3d printable design

Dimensions:

Please note that the adjustable dimensions are measured inside. The model has a shadow gap to prevent light from shining through the seam. Due to that shadow gap, you need to add 3mm to your desired length or width if the dimensions are crucial!

Assembly:

1. the lid snaps into the provided recess. Place the lid on one side into the hole and apply gentle pressure from above → snap!
2. Take a spring with a diameter of 6 mm and a length of 10 mm, or simply take spring from a used ballpoint pen and cut it to a length of 10 mm with side cutters.
3. takwe the push button and place it in the recess, pushing it forward with the nipple through the hole.
4. compreess the spring with tweezers and place it in the provided recess. Check the correct fit of the spring and test the push button.
5. if the push button moves freely → done!
6. have fun with it!