Spooky Skeleton Pumpkin Halloween decoration. The model can be scaled up or down to your liking.  

I printed one in Orange at smaller 50mm size then decided that I needed a full size one, increased to 450% in BLACK that looks awesome too! 

Included are Print profiles for a complete model for H2D/H2S, as well as a NO AMS version on 2 plates for single nozzle P1/X1/A1, last i threw in a A1MINI version as well!  

Make sure to keep the pumpkin 10% Lightning IN-FILL to keep it light and use less filament.

If you print the NO AMS version make sure to keep the support on the fingers [Normal - Snug] so they pull right off.

Glue the fingers and the stem onto the pumpkin according to the numbers inset onto them:

If you can't read them, then refer to #8 as the “thumb” with only two joints and go around from there.