I present “Yet Another PS4 Controller Hanger”, compatible with multiboard and 3M command strips.

This model is a low filament (<20g in either version), low complexity model which was designed to ensure your PS4 controllers can hang in style and pass the “oops, I bumped it a little” test (or “bump” test, for short). I've specifically designed the bottom to be framed around the shape of the controller to help it sit firmly in place without pressure on any component. The back has been angled to match the controller's shape and it also has slight “shoulders” that should help the curved back of the controller to find its center again when nudged.

The 3mf file contains two plates:

• one with a multiboard click hook
• one with a flat back compatible with 3M command strips
  • I recommend two “small” size strips, but a “medium” size should fit as well.

A note on supports: supports are required for the multiboard click hook variant (<1g), however, supports can be turned off entirely for the command strip version as the front “chin” can print without a support. A support will always make it nicer and cleaner, but the gains are minimal in all my testing.

This model is original (besides the multiboard click hooks, of course), but I would'n't have made it without first being exposed to the following models and getting some inspiration from them and their creators. If this model doesn't suit your needs, then perhaps one of theirs will:

• calvin25011999's PS4 Controller & Headset mount
• Tetraflops's remix of the above PS4 controller mount
• TwoPuncakes's PS5 Dualsense controller wall mount
• Omochimushi's remix of the PS5 Dualsense controller wall mount