Organize your baseball caps with this Gridfinity-compatible hat stand that holds up to 6 baseball caps. Built with the standard Gridfinity baseplate footprint, it integrates directly into your existing setup.

Stores 6 baseball caps neatly in angled slots

⚠️ Please note: This stand is designed for curved-brim baseball caps. It is not compatible with flat-brim hats.

•  Angled design keeps hats from slipping and aligns brims cleanly
• Gridfinity-compatible base – locks into your modular system
• Geometric honeycomb sides for a modern look and reduced filament use
• Great for desks, closets, or display shelves
• Strong, single-piece print – no assembly needed

Perfect for hat collectors, everyday wearers, and Gridfinity enthusiasts who want a clean, modular storage solution.

Recommended Print Settings:

• Material: PLA or PETG
• Layer Height: 0.2 mm
• Infill: 15–20%
• Supports: Not required
• Bed Adhesion: Standard

Note: This design is intended for longer-term storage and display. Because the hats are stacked at an angle, pulling a single hat from the middle may cause others to shift. I prioritized maximum storage capacity (6 hats) over quick grab-and-go access.