Tired of reaching around or through your printer just to turn it ON or OFF? 

This simple but effective mod brings the power switch to the front of your A1 mini. 

No more awkward stretching, just slide it under your printer and use!

This is a version for A1 mini printer, other models available:
 

Any Material – PLA, PETG, ABS… works with whatever filament you have, BUT make sure to select at least 5 walls, 25% infill and 5 top / bottom shells. because those parts are large and want to bend a little - but we need them to be sturdy.
No Extra Parts or tools needed – no screws or any other hardware needed (in some cases you need superglue)

Easy Installation – just lift the printer slightly and slide it under, and look for feet to be in their places.

Space-Saving – no extra clearance needed at the sides or back

Hot-Swap Ready – can be installed even while the power cord is plugged in and printer is on (be careful)

Lock ready - you can use plastic click lock against accidental push, or install real mini lock.

Print and click all together like in this drawing. 
First click together A & B, and then click together C.. to get it right, place it on the table or twist it a little bit.. it should click in place nicely.
When printing full plate objects, it's better to turn on manual plate calibration.

With this extender, you’ll always have fast and convenient access to your power switch — without changing your setup or disassembling  your printer. Additionally, if you want, you can print button from other color, and print ON/OFF letters, look for them on 3rd plate.