UPDATE

If you want the Knitted version of this Balloon Dog click on the image below!

A cute balloon dog :)

The profile is set to print at different speed especially for the tail and the nose area.

Enjoy

UPDATE 

Added a profile for better overhang supports, especially for underbelly and face. Obviously the supports will be a bit harder to remove but hey you can't always get what you want :)

I've canceled the two other profiles (tree support and fuzzy skin) until I got the same overhang results, so stay tuned!

TIP

In case you print with dark filaments, especially with matte finish, it's possible you'll have some white spots like these, after removing the supports:

If so just use a butane torch and pass the flame rapidly on these zones and you'll have the natural color again: