My existing killflash from novritsch got shot out, and I still wanted to use the killflash body, so I just made some new honeycombs for the killflash body so we can re-use it endlessly. The killflash was made with slightly thicker combs and 4mm thickeness to ensure that this thing stays in once peice, at least for a couple shots.

Documentation:

For those who didn't even know these could be replaced, see the photos below for a step by step guide.

1: Print your new honeycombs

2: Grab your killflash with the back (or screw on portion) facing towards you.

3: There's an inner ring that can be grabbed with your nail, plyers, or a flathead screwdriver, unscrew this ring by turning it counter-clockwise.

4: Push out your damaged killflash honeycombs from front to back. You should now have three seperate peices layed out.

5: Grab your new printed honeycombs and insert it into the housing. NOTE: It should be a tight fit, You'll hear a little click or two, that means it's seated inside the housing.

6: Re-attach the inner ring to secure the new honeycomb into place.

7: your new killflash for your 3-9x variable sniper scope is ready to use