Meet Puffer Pal: a cute, round pufferfish with a crochet/knit surface, big cheeks & lips, side fins, and expressive eyes.
For a clean print and crisp texture, the model is split into two halves:

• Front half: multicolor (eyes: white + black pupils via AMS, set Purge Value to 2 or higher)
• Back half: single-color body

The halves join with press-fit connector plugs (included). The overall result is a sturdy, huggable desk buddy that shows off that cozy knit texture.

Size (assembled): ~95 × 115 × 95 mm
Suggested colors (example): BambuLab Yellow body, Matte White for eyes, Black for pupils.

Supports: None on the exterior; only small Tree Supports inside the peg/sleeve cavities (and occasionally a tiny branch under the knit overhang—rare and easy to remove).
AMS: Recommended for the front half to auto-place white and black in the eyes.

Printing

• Orientation: Print each half flat on the cut plane for best surface quality.
• Walls/Perimeters: 3–4 (locks in the texture; improves peg grip)
• Layer height: 0.20 mm
• Supports: Tree Supports only in the internal connector zones (enable support painting if you want to be surgical)

Assembly

1. Fit the connector plugs in the sockets of each half.
2. Align the seam and press halves together. (Optional tiny dots of glue if you want a permanent bond, but it should stay together either way.)