Project: Starry Cat
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x200mm in size
You may print at higher layer heights below the Base Thickness of 0.64mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.16mm

This print uses 7 unique filaments
PLA BambuLab Basic Black 
PLA Bambu Basic Mistletoe Green 
PLA Bambu Basic Cobalt Blue 
PLA Bambu Matte Ice Blue 
PLA Bambu Matte Dark Red 
PLA Bambu Basic Yellow  
PLA BambuLab Matte Ivory White

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Mistletoe Green
At layer #10 (0.88mm) swap to Cobalt Blue
At layer #12 (1.04mm) swap to Ice Blue
At layer #15 (1.28mm) swap to Dark Red
At layer #17 (1.44mm) swap to Yellow
At layer #24 (2mm) swap to Ivory White for the rest.