About

This is simple hexagonal container. it has snap-fit connections so all the containers can be joined together. top part has narrowed lip so the containers can be stacked one on another.

How to print

Just turn on vase/spiral mode in your slicer and increase line width for external perimeter (at least to 0.6mm but 0.8mm should result in stronger container). It's good idea to also increase the bottom thickness to 1mm. 

I prefer PETG for this model as it tends to have better between-layer connection and also is less brittle than PLA. ABS should be also OK. If you want the container to be watertight - consider increasinf flow rate by a percent or two - just to be safe.

Have a nice printing :)