Waterproof boxes in two sizes to carry smaller items with TPU gasket so they pass the underwater test. Has a lanyard hole so you can attach it to keychains or to backpack, great for EDC. Has Bambu Lab logo but you can remove it and customize it with your own or leave it blank. It also has water drop anti-slip embossed texture.

Four version available:

1. Small dual color for AMS
2. Small no AMS version with embossed logo
3. Large dual color for AMS
4. Large no AMS version with embossed logo

*** WARNING: Do not use matte, silk or any other filament with weak layer adhesion for the case. The screws cut their own threads and the case will crack if you use those filaments. If you insist on using one of those filaments you will have to heat up the screws before cutting the threads to avoid cracking. ***
 

You will need three M3x16mm screws to assemble it. The gasket is friction fit inside the groove. When assembling please follow the steps below:

1. Cut the threads with the screws and remove them, clean any excess material.
2. Attach the lid to the body making sure the water sealing groove mated properly, only then attach the hinge screw.
3. Attach the closure.
4. Insert the TPU sealing gasket, a small flat head screwdriver can help.

You can also scale the closure tab in slicer to adjust how tight/loose it is to fine tune it. The locking groove has very tight tolerances to make it pass the underwater test. Please make sure your filament is well tuned before attempting to print this model!