一款tpu鞋垫，下雨天户外活动鞋子打湿也不会吸水。

打印之前强烈建议先打印测试模型，测试是否适合您的脚大小。现在默认是42码的缩放。

可以参考我的方法，如下图，先把模型旋转成竖直摆放，点击缩放查看大小。Z缩放100%是5mm，建议不要改变。

测试模型建议用PETG打印+brim

成品模型：20%以下蜂窝填充；

顶部、底部壳体为0层；

----------------------------

A TPU insole that won't absorb water even if your outdoor shoes get wet on rainy days.

It is strongly recommended to print a test model before proceeding to test its fit for your foot size. Currently, the default setting is for a size 42 scaling.

You can refer to my method, as shown below. First, rotate the model to a vertical position, and click on the zoom to view the size. The Z zoom is set to 100% which is 5mm, and it is recommended not to change it.

It is recommended to use PETG printing with a brim for testing the model

Finished model: less than 20% honeycomb filling;

The top and bottom shells are of 0 layers;