Wastelander, stop by for a cold refreshing Nuka-Cola Quantum!

It's a lamp when the LED is powered on, and … it's still a lamp while the glow filament is charged up. The end resulting model should be around 2.5"x8".

I used PETG Translucent light blue for the bottle, PLA Glow blue for the glow sleeve, and PLA Silk+ silver for the bottle cap.

Items sourced from BambuLabs:
1: LED Lamp Kit - MH001

Other items:
Aleene's Clear Gel Tacky Glue
[https://a.co/d/gfnfiwo](https://a.co/d/gfnfiwo)

Assembly:
Print the enclosed label ncq_label.pdf and cut it to size

Laying out all of the pieces should look like this


Insert the glow sleeve into the base of the bottle


Insert the LED Lamp Kit - MH001 into the base of the bottle so that the wire hangs out the wire port in the back

Connect the bottle cap to the top of the bottle, it should fit snugly without any adhesive but feel free to use any you like

I poured three lines of the tacky glue to the back of the label and then smeared it as a thin layer, and then positioned the label into place so that the ends touched and it looked straight enough

If you put the glue on too thick it might ruin the image on the paper, so act quickly and carefully or you'll be printing and cutting a new label.