A stand for combining a Flex Radio Systems FlexControl and a Stream Deck MK.2 (15 button).  This stand places the Stream Deck at fingertip height when using the FlexControl and adds additional control and function buttons when operating the radio software.  Both the FlexControl and the Stream Deck drop in without additional hardware.  The USB cables for both devices route out the back.  

I used ½ inch diameter Clear Adhesive Bumper pads on the bottom of the stand to keep it from sliding around my desk.  These bumpers are not necessary, but I modeled locating circles on the bottom of the console.

Updates:  I removed material on the top edge to provide clearance for the cord on the original 15 button Stream Deck.  Supports are strongly recommended for the top edge since its a very long bridge.  In the latest print profile I have turned off "Remove small overhangs" and painted in extra support on under the top edge.

If you have a StreamDeck XL, please check out my other design at [https://makerworld.com/en/models/1963458-flexcontrol-and-stream-deck-xl-stand#profileId-2268460](https://makerworld.com/en/models/1963458-flexcontrol-and-stream-deck-xl-stand#profileId-2268460)