See original model for assembly instructions: [https://makerworld.com/en/models/839922-pokeball#profileId-785849](https://makerworld.com/en/models/839922-pokeball#profileId-785849)

Profiles and models for the Generation II Pokeball designs. The lid geometries have been modified from the original design, but identical mounting alignment pin patterns make them inter-compatible.

Misc. Info:

• The print-in-place ring mechanism has two versions with different tolerances. Make sure your elephants foot compensation is set properly to prevent the hinge from seizing.
  • The loose version has a minimum gap size of 0.3mm, and should work with most (non-bambu) printers
  • The tight version has a minimum gap size of 0.2mm, and should only be printed if you are confident with your printer's capabilities
• The magnets I used measure 6mm x 1.75mm (6x2 nominal). I got them from amazon: [https://www.amazon.com/gp/product/B07KJ9H31P](https://www.amazon.com/gp/product/B07KJ9H31P)
• Printable alignment pins are included, but you can use machined pins too

For Assembly Instructions and Troubleshooting Tips, see the original model