[WARNING]

Original version of model is Only Compatible with RC-V6E2(Not RC-V6) cartridge.

The cartridge requires 30mm * 1.5mm rubber band

Please Print All Compatible profile for other version of cartridges.

DO NOT cause impact to the loaded cartridge.  It might launch itself.

[PRINT SETTINGS]

[The Gun]

Layer Height: 0.28mm

Wall: 2

Infill: 8%, gyroid

Support: linear/grid

[The Cartridge]

Layer Height: 0.28mm

Wall: 1

Infill: 5%, gyroid

Support: tree

[ASSEMBLY]

[CHECKING]

1. After printing the cartridge,  push the bottom of the casing to loosen the spring.
2. Insert the rubber band and the projectile and push the bottom of the casing to see if the cartridge works.

3. Remove the chamber of the gun and see if the hammer works properly.

You can put your finger on the hammer to see if the hammer is stong enough.

If all above are fine, It should work fine.