This is a case designed for the AMENG multimer.

But other testers may well fit.

2 compartment extra storage in the lid for extra test leads.

I have found a problem with hinges breaking on other boxes I have downloaded and printed. 

The hinges were too small and tend to break easily.

To rectify this problem I have made the hinges bigger (10mm diameter).

See the profile I have loaded to help prevent warping on the corners when printing the box.

Bed temp = 70

Aux fan = off

Assembly -

The hinges need two M3 x 30 set screws.

I had to clean up the hinge thread on the lid with an M3 tap after printing.

If you do not have a M3 tap, just use the M3 screw but saw 2 slots in the end of the thread to help clear out the thread after printing.

The separator plate just slides into the grooves in the lid and locks into position.

Dimensions. W120 x D180 x H55mm

If you want a different size case message me with your dimensions and I will try to upload it for you.