LED Lamp Kit Lighthouse Lamp

NO SUPPORTS NEEDED!

will also work with a battery tealight (If using tealight, print the translucent glass part in ‘vase mode’ so the it prints a base to hold the tealight), but works best with the bright light of the LED Lamp kit.

Features translucent PETG (or PLA) for the top of the lighthouse to simulate the look of a real bulb shining through! Swap out the coloured translucent filament for different looks!

Prints in multi parts. No glue required.

You can print this without an AMS, just pause the print at the desired place for color changes

Assembly:

1: Drop light into main section, usb end first and feed wire through hole in the base

2: Screw Lattice Section onto Main Section

3: Drop down optional Light blocker into the main section (If using)

4: Drop Translucent ‘glass’ down into Lattice Section

5: Place Roof on top

6: Press fit Windows in place

7: Use filament to feed through the railings (be VERY gentle, to not break the railings.) or use string (easier option). if the holes are to small you can use a 2mm drill bit to widen them

8: turn on

9: Enjoy Ambiance :-)