HUNTRIX Fans Unite!

This is a replica of the HUNTRIX light wand seen during the opening concert and the Idol awards in Kpop Demon Hunters. It is a great prop for any HUNTRIX fans to cheer on their favorite Demon Hunter.

Please leave a comment and show off your builds! 

Final Update:

I have finally made some changes that were much needed, mainly fixing the direction of the “H” in the wand. With this final version I also added few QOL features shown on the official wand. There is now an insert version with multi-color H to match the official wand, and a lighty diffuser that helps give the wand some shine. I also adjusted the inserts a hair to fit better without glue. Please note, the inserts are semi-directional. They will fit in either side, but they'll fit a bit better in the one. If you have to force it, try the other side.

New Print Profiles:

Single-Color Kpop Demon Hunter x Light Stick Final - This profile should be used by most to avoid excess color changes for the handle. This profile does have a plate with the multi-color “H” on the insert, or a plate only single colored.

Multi-Color Kpop Demon Hunter x Light Stick Final - I HIGHLY recommend that this profile only be done on the H2D or H2C. This profile has the text in the handle colored and is almost 500 color changes. It's a lot of waste if you only have one nozzle.

Saja Boy Fans Rejoice!

For all of those requesting the Saja Boys wand, I have collaborated with Xallex Digital Design to create the Saja Boys wand Using the same tea candle! Check out his model here! [https://makerworld.com/en/models/1740186-k-pop-demon-hunters-saja-boys-illuminated-wand#profileId-1849209](https://makerworld.com/en/models/1740186-k-pop-demon-hunters-saja-boys-illuminated-wand#profileId-1849209)

Recommended Filament & Parts:

• Head: Transparent filament.
• Inserts: Multicolor or Silk gradient PLA (Purple/Blue/Pink) + white for “H” (optional).
• Handle: Silver filament + Purple (optional for multicolor).
• Light Source: Bambu Tea light or Amazon [https://amzn.to/4mssCQ3](https://amzn.to/4mssCQ3)

Assembly Instructions:

1. Drop in the Diffuser panel, then Press-fit the multi-colored Inserts into the transparent Head. For a permanent hold, a small amount of super glue can be used.
2. Turn on an LED tea candle and place it into the top of the Handle.
3. To attach the head, align the tabs on the bottom of the Head piece with the L-slots on the top of the Handle.
4. Push the head down gently and twist to lock it securely in place. If tight, wiggle it on and off. It gets easier after a couple times.