This is the wall mount for the EGO 765 CFM leaf blower.  If you have the 615, 650, 670, 880, use this version:

[https://makerworld.com/en/models/1016195-ego-leaf-blower-wall-mount](https://makerworld.com/en/models/1016195-ego-leaf-blower-wall-mount)

After several design iterations with a helpful user here on makerworld, the design is finalized and ready for your use.  This mount is configured for the EGO 765 CFM leaf blower with the inlet screen right at the mount, like the image below.

No support is required for the overhang:

Notes:

• If you make your own print profile, make sure there are a minimum of 5 walls and 5 bottom and top layers
• Take it easy with the impact driver :-)

Check out my other EGO tool-related prints here:

• [https://makerworld.com/en/models/1313687-ego-string-trimmer-weed-eater-wall-mount](https://makerworld.com/en/models/1313687-ego-string-trimmer-weed-eater-wall-mount)
• [https://makerworld.com/en/models/424747-ego-56v-battery-mount](https://makerworld.com/en/models/424747-ego-56v-battery-mount)
• [https://makerworld.com/en/models/1670876-ego-765-cfm-leaf-blower-wall-mount](https://makerworld.com/en/models/1670876-ego-765-cfm-leaf-blower-wall-mount)

Revision history:

• Rev 2: taller design than the 650 CFM model, initial development concept
• Rev 3a: thicker design (one might say, so thicc), another inital development concept didn't work
• Rev 4: full redesign, new structure, additional clearance to the shroud
• Rev 5: almost there
• Rev 6: final release