Ergonomic adapter for choc keycaps to give it some tilt / height so they are easier to press. In the photos I have them installed on my ZSA Voyager. They make the top row of keys easier to press as it brings it closer to my fingers. 

No supports or brim is needed to print. Print on high quality 0.8mm.

On plate two you can print ones that are horizontal.

If you use the uploaded profile it should be good. Sometimes the tolerance is too tight when inserting into the switch, so make sure they go all the way into the switch before placing your keycap on it.

The tenting leg used in the pictures is available here.