Fully customizable sliding box, create your own version by adjusting the parameters.

If you want to create your own box that suits your needs, or even an entire shelf, then you've come to the right place.

Simply adjust the parameters to your requirements and a few hours later you'll have your own version in your hands.

Features:

•  Adjustable width, length, and height
•  Adjustable side pattern
•  Adjustable pattern inside the drawers
•  Adjustable number of boxes next to and above each other
   

Assembly:

Simply insert the drawer from the rear; with a little force, it should snap into place and be ready for use.

If you want to remove it again, you can simply push it back out with a little force.

Print settings:

The model can generally be printed without support structures. Print the housing as vertically as possible, with the drawer on its base.

This is my first parametric model here on Makerworld, so I would appreciate any comments and tips you may have.

I am very excited to see how you like this model and how you use it. I look forward to seeing you in the comments section :)