This is a ring holder for 1, 2, or 3 rings. It is suitable for storing rings on your bedside table or in the bathroom at night.
The slot dimensions are freely configurable.

Default settings:
Width: 5.2 mm
Length: 25 mm
Depth: -9 mm

These dimensions are well suited for men's rings. The width should be configured 0.2 mm wider than the actual ring.

For smaller women's rings, I recommend a default length of 23 mm and a depth of -8 mm.

I would generally recommend setting a pause at layer 60 and then canceling the print. This allows you to adjust the slot dimensions again and save filament.

Customize:

After clicking on customize you can choose 1, 2 or 3 rings. After that you can adjust the values and click on download:

Alignment:

After downloading, the model must be aligned correctly.

Click on the model and then on the yellow marked button:

After that click on the surface with the slot:

This is the correct allignment!

Print settings: 

Wall generator: Arachne

Otherwise standard settings

Assembly:

For a secure stand, you can attach self-adhesive silicone feet with a maximum diameter of 10 mm. See last photo.

See also my new ring holder: LINK