The Interchangeable LightBox!   The lightbox that you can change the face on!  

I designed this so the faceplates can be swapped out with others by sliding it out the top.  I preferred this over the lightbox you can create in MakerLab that you cannot change the face on and can take a long time to print depending on the design.

I have this setup to use the USB powered Bambu Lab MH001 Lamp Kit.  The light should fit snug but you can always install it the with double sided tape that it comes with or a couple dabs of glue.  I also recommend removing the white lens from the light as this will make the lights brighter.  The RGB multicolor lights can be found here:  [https://www.amazon.com/dp/B0F7SKM268?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1](https://www.amazon.com/dp/B0F7SKM268?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1) 

The inside back of the lightbox housing is white.  This helps with light reflection.

Printed with PLA Basic Black and White.

If you have a logo or anything you would like added to a faceplate.  Please send us a message and we will design one.

This will not work with the A1 Mini due size.

*** WORK IN PROGRESS:  I will be slowly adding several print profiles for the front face plates.  ***