This version is for the bolted version of Lab rax - see my other posts for the heatsink versions

[https://makerworld.com/en/models/1321019-lab-rax-customisable-depth-spacers#profileId-1357193](https://makerworld.com/en/models/1321019-lab-rax-customisable-depth-spacers#profileId-1357193) For heatsink version.

This compute blade case is deeper than the Lab Rax case, so I made a customisable side post in scad to allow any depth of case to easily be created.

The SCAD has four parameters

The total depth parameter, which is the total depth of the case, (the generated beam will be 70mm shorter than this)

The handles hole width parameter specifies the distance between the centre holes for the handles (or feet). Setting this to zero will remove the holes.

The U height parameter sets how high you want to go.

The Brass_Insert_Hole_Diameter allows you to tweak the diameter of the holes for the heat set inserts

Solid Panels for the side and top will also be generated. The depth of the panel and the slot it fits into on the posts can now be customised, I was using 2mm panels but the original was 3mm, either way you can now set it to what you like.

Default handle depth has been changed from 125 to 127.5 mm

[https://makerworld.com/en/models/1376106-lab-rax-cable-management-for-10inch-19inch-rack#profileId-1423617](https://makerworld.com/en/models/1376106-lab-rax-cable-management-for-10inch-19inch-rack#profileId-1423617) For front to back cable management

See [https://makerworld.com/en/models/1365647-lab-rax-honeycomb-storage-wall-panels-custom#profileId-1411265](https://makerworld.com/en/models/1365647-lab-rax-honeycomb-storage-wall-panels-custom#profileId-1411265).  for a hsw honeycomb storage wall compatible  side panel

[https://makerworld.com/en/models/2668114-lab-rax-construction-brick-side-panel-customisable#profileId-2952758](https://makerworld.com/en/models/2668114-lab-rax-construction-brick-side-panel-customisable#profileId-2952758) For Lab Rax toy construction brick side panels