逛了好久的makerworld网站，下载了好多花洒支架，但都有或多或少的缺点，要么不好看、要么角度不可调、要么不好打印，于是历经几天的反复修改，最终设计出一款我自认为比较完美的花洒支架，它有以下优点：

1、一款专为3D打印设计的花洒支架，无支撑，工艺参数已经特别优化，上传2种配置参数，可一键打印。

2、无支撑，齿轮设计、多种角度可调，简约时尚。

3、推荐使用PETG打印，使用时间比较长久。

4、螺纹公差0.2mm，如果螺栓拧不了，可以适当增加XY的孔洞补偿，然后重新打印。或者适当缩放螺栓（只缩放XY），单独打印螺栓。

I have been browsing the Makerworld website for a long time and downloaded many shower stands, but they all have some shortcomings, such as not looking good, not adjustable angles, or difficult to print. After several days of repeated modifications, I finally designed a shower stand that I consider to be quite perfect. It has the following advantages:
 

1. A shower stand designed specifically for 3D printing, unsupported, with specially optimized process parameters. Two configuration parameters can be uploaded for one click printing.
 

2. No support, gear design, multiple adjustable angles, simple and stylish.
 

3. It is recommended to use PETG printing as it has a relatively long usage time.
 

4. The thread tolerance is 0.2mm. If the bolt cannot be tightened, the XY hole compensation can be appropriately increased and then reprinted. Alternatively, scale the bolts appropriately (only XY) and print the bolts separately.
 

If the model is helpful to you, please ask for assistance and support. This will be my motivation to continuously update original models... Thank you for your support...