This model is a quick and easy print that is enjoyable by anyone! I got lots of great comments on my 1st tree face so I thought may as well upload a V2! 

            The improvements for this one was,  1   I upscaled it to almost 2X the size.  2    I added notches around the side of the hole so you don't need magnets, instead you just need nails.  3  I changed allot of the print settings so it uses less filament. (it almost uses the same amount of filament as the smaller one).

                This model is very easy to assemble.

What you need:    4 Nails 

                                  Tree to hang it on

                                  Hammer

What you need to print:      Eyes

                                                 Nose

                                                Mouth

              Start by hammering the nails in one at a time leaving each nail sticking out about 1 inch. (This is what the nails should look like).

                     Once you get the nails in, put each piece in the proper postions.

                                                                                  Both Eyes at the top

                                                                                  Nose in the middle

                                                                                 Mouth at the bottom

                                       But make sure when putting each piece to the tree that it is snug and isn't hanging there. There shouldn't be any gap                          in between the tree and the 3d printed piece. It might be ok if it is partially hanging just it will fall off easier.

                                     This is one of the eyes on mine…. 

                                     Once you're all done, your good. You can keep it the normal way or I did make it so you can change the expression!

                                       These are some ways I put mine to.

Here is the link to my first one!

[https://makerworld.com/en/models/1544701-tree-face-with-multiple-expressions-ams-needed](https://makerworld.com/en/models/1544701-tree-face-with-multiple-expressions-ams-needed) 

                                                                              [https://makerworld.com/en/@Bardownskiiz](https://makerworld.com/en/@Bardownskiiz)