Version 2 is out! It improves upon this design in a few ways:

• The 2-row version adds a little height to make it easier to load the dispenser when another is stacked on top.
• The backstop is higher to prevent cans falling out the back.
• The pattern on the side is different to prevent the cans getting stuck.
• The tolerances on the joining pieces are adjusted to make the surface flatter.

This is a stackable soda can dispenser, designed to be sturdy and easy to assemble. No supports required.

I have provided two versions - one for a single row of cans, and one for two rows of cans. These are 6 cans deep, about 16¼ inches. Each print profile includes an optional set of flat tops you can use to rest something else on top of these.

I have printed this in both PETG and PLA, and both work well. They stay together without glue using friction, but glue will make it stronger.

If you need dispensers for different can sizes, let me know the exact diameter and height of the cans and I should be able to make new models pretty easily. And if you want different sizes for smaller fridges, let me know and I'll see what I can do.