This is a 1/24 - 1/28 hinge I have designed for RC drift car's or any RC car's than you wish to use it on. It can be used for doors, bonnet's or boot lid's.

For the wire through the centre I have used a ¼w resistor wire, the hole for this wire is tiny, it is only 0.5mm in diameter so you must take your time and be careful when inserting it as the hinge could brake.

I insert the wire while it is attached to the resistor still to make it a bit easier. you must make sure your printer is calibrated well if you want to have the highest chance of this hinge working.