Original artwork - Ballet dancer - hueforge
The photos shows the result in 200*150mm and a nozzle of 0.4

You can change the X and Y dimensions but do not change the Z dimensions  
You must define the printing parameters indicated in the description below and change the filament on the indicated layers.  
You can use filaments other than those indicated, but the result will differ.  
You can use any black PLA

Hueforge description
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 150x200mm in size
You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 1.43999mm

Filaments Used:
    #000000 PLA BambuLab Basic Black  Transmission Distance: 0.6
    #4c5f71 PLA BambuLab Basic Blue Gray  Transmission Distance: 3
    #ffffff PLA BambuLab Basic Jade White  Transmission Distance: 5
This print uses 3 unique filaments

Swap Instructions:
    Start with BambuLab Basic Black
    At layer #8 (0.72mm) swap to BambuLab Basic Blue Gray
    At layer #11 (0.96mm) swap to BambuLab Basic Jade White for the rest.

No additional copyright, this is my original work