Be sure to visit my profile page to find more fantastic models!
[https://makerworld.com/en/@cP3D](https://makerworld.com/en/@cP3D)

I have created another clock here. Perhaps some of you will also like this clock.
I imagine this clock would also make a lovely gift for someone.

I have created a 170 mm and a 245 mm version for wall and table use

If you wish to enthuse others about these clocks, please share the link on social media.

Here you will find only the clock faces!
The necessary accessories can be found at the following link:

[https://makerworld.com/en/collections/4894074](https://makerworld.com/en/collections/4894074)

To minimize print time without compromising quality, I have configured height range modifiers in my print profiles. So, don’t be surprised if the swap instructions don’t match the data in the print profile

Print at 100% infill with a layer height of 0.06mm with a base layer of 0.12mm

Swap Instructions:
    Start with Black
    At layer #21 (1.32mm) swap to Jade White for the rest.

If you receive the message about overhanging areas during slicing… you can ignore it
 

Here you can find a collection of my other clock faces
[https://makerworld.com/en/collections/1715414](https://makerworld.com/en/collections/1715414)