Rag Hanger with Round Hook Loop

An adaption from finniminni's Rag Label Clip with Hanger model to which I added a round hook loop for easier use with different hooks. I made the hook thicker and the clip itself is now a bit more stiff to hold wet towels better. I also made a heavy duty version with sharp teeth to hold even the heaviest towels and withstand tossing around.

Printing

For use in bathrooms and in other humid/harsh conditions I recommend printing this out of ABS or ASA for better durability. PETG should also work well and is even easier to print - I have also included a profile for that with PLA supports. I didn't test printing it without a brim but from experience for such a small part I recommend using a 3-5 mm brim. I have included PLA profiles for both versions and also a hacky ABS version recommended for dual nozzle printers like the H2D. This ABS version:

• Duplicates the first layer and prints it in PLA for better bed adhesion and less warping - this first layer can be later peeled off
• First PLA layer allows to drop the bed temperature to 60° C
• Lowers the chamber temperature to 55° C
• Also uses PLA as support interface with zero clearance
• Overall it promotes easier printing of ABS and lower energy consumption

Printing this on single nozzle printers is very possible but may take considerably more time since the nozzle has to heat/cool down between filament changes due to different printing temperatures. For this reason I recommend turning off PLA support interface, using normal supports with adequate distance and only using PLA for the first layer when printing with a single nozzle printer. The same applies to the PETG profile.