A fairly basic infill-type coaster set of 4, with a holder that does what it's supposed to do, and admirably at that.

Please note that this design was created entirely from scratch, even though similar coasters may exist due to the simplicity of the geometry—after all, it’s just a circle.

Anyway, here’s some basic info (your results may vary depending on how you fiddle with the slicing):

🟠 Coasters (each):

• Diameter: 90 mm
• Total Thickness: 7 mm
  • Base: 1 mm
  • Infill Pattern Depth: 5 mm
  • Top Lip: 1 mm

🔵 Holder:

• Outer Diameter: 100 mm
• Total Height: 32.5 mm
  • Center Section Height: 30 mm

I’ve had a bit of stringing on the infill pattern—most likely due to print speed. It’s minor and doesn’t bother me, but I encourage you to tweak the settings and make it your own.

The infills I like and used are Honeycomb, Cross hatch, Octagram Spiral and Hilbert curve.

PLA I used was Bambu Labs Basic PLA for the purple ones and Winkle PLA Matte for the black components.

I welcome all critique, lay it on me, this is my first model I've made, so don't hold back any punches!