Information:

This is my first project created in Fusion and I'm very happy with it. It wasn't difficult to mount a new spool in the back, but it wasn't the greatest. I designed this to use the screws from the factory spool bracket, and just two additional screws.

Print in Place: 

No

Required Hardware:

2x M3 x 16 Screws

2x M3 Washers

2x M3 Nuts

Assembly:

1. Print and connect the two brackets together. 
2. Remove the stock spool holder. 
3. Secure the the stock spool holder to the top bracket with the two M3 screws. 
4. Secure the lower flat bracket to your P1S (mounts only one way), with the stock screws.
5. That's it!

Notes:

I am working on a PTFE filament redirect to the side of the printer. But this setup has made my life that much easier to quickly swap between spools.