After slightly damaging my mom's new resin  table with my cup of tea, I decided to make some coasters to prevent it from happening again and they turned out nice enough that I wanted to share them.

Model Information:

• The outer diameter is 9 cm
• The inner diameter is 8,6 cm
• Bottom is 3 mm thick
• Total height is 6 mm
• Designed to be stackable

Printing Information:

• The top pattern is 0,2 mm tall and should fit the layer height of most printers
• The top pattern has thin parts and require arachne wall generator or thin wall detection to slice properly
• Supports required, if supports aren't generating make sure remove small overhangs is turned off