Picture source: Skull-Tastic

Then used HueForge v0.8.1 to create the model.

Important info! 

Slicing this model takes quite a while, about 3-4 minutes depending on the performance of your PC, so please be patient. The 200x200mm version is hell long! :D

 The Model is 150x150mm in size.  You can only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct.  You may print at higher layer heights below the Base Thickness of 0.48mm. The Max allowed Thickness is 2.16mm and the Actual Thickness is 2.16mm.

Filaments Used:

PLA Anycubic Black Transmission Distance: 0.3

PLA Sunlu Meta Grey  Transmission Distance: 3.5
PLA Elegoo Basic White  Transmission Distance: 7
This print uses 3 unique filaments

Swap Instructions:
    Start with Black
    At layer #8 (0.72mm) swap to Grey
    At layer #12 (1.04mm) swap to White for the rest.
 

Share your prints and…