Hey there everyone, I am new to the 3d printing industry with a Bambu Lab A1 I had gotten quite recently. I wanted to print the brick pieces I was missing and/or broken, but I had troubles with getting the stud sizes right. My caliper reads different bricks' studs differently, so I resorted to printing bricks with different stud measurements (millimeters). I found a model here which is titled ‘Brick Stud Size Test’ here in MakerWorld so I printed it out, but the 5mm there was not good for me for some reason. I use PLA Basic as my filament. 

So I created this one from scratch in TinkerCad and Bambu Studio, patterned after @luckyluke1351's ‘Brick Stud Size Test’ project but this time with 5.05, 5.08, and 5.1mm diameter studs.