Filament sample cards for Bambu PLA Basic filament.

This can be a somewhat tricky print because of the 0.1mm first layer. The default Bambu PLA flow ratio is sometimes a little bit too low, and increasing this slightly (ie: from 0.98 to 1.00) can help a lot. Increasing the 1st layer temp by 10 degrees and making sure you have a clean bed will also help.

This is a ground-up replacement for @fenglyu's Filament Sample Card design, compatible with most accessories for their standard-sized swatches. The outer dimensions, corner radius, and hanger clips match the existing design while the inner area was redesigned to highlight printed text instead of an adhesive label.

See also:

• Bambu PLA Basic - [https://makerworld.com/en/models/1576305](https://makerworld.com/en/models/1576305)
• Bambu PLA Matte - [https://makerworld.com/en/models/1402144](https://makerworld.com/en/models/1402144)
• Bambu PLA Silk & Multi-Color Silk - [https://makerworld.com/en/models/2025075](https://makerworld.com/en/models/2025075)
• Bambu PLA Silk+ - [https://makerworld.com/en/models/2025588](https://makerworld.com/en/models/2025588)
• Bambu PLA Wood - [https://makerworld.com/en/models/2029186](https://makerworld.com/en/models/2029186) 
• Bambu PETG HF - [https://makerworld.com/en/models/2029542](https://makerworld.com/en/models/2029542)