509th Bomb Wing Patch as a HueForge!

If you resize, just be sure to keep the original Z-value in order to keep layer-based color changes accurate!

Project: 509BWLogo.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
    PLA BambuLab Basic Blue Transmission Distance: 4
    PLA BambuLab Basic Red Transmission Distance: 4
    PLA BambuLab Basic Yellow Transmission Distance: 6
    PLA PolyLite White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Blue
    At layer #8 (0.72mm) swap to Red
    At layer #13 (1.12mm) swap to Yellow
    At layer #20 (1.68mm) swap to White for the rest.