Project: Wolverine.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 254x143mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
    PLA Elegoo Black Transmission Distance: 0.2
    PLA Elegoo White Transmission Distance: 5.5
    PLA Elegoo Grey Transmission Distance: 2.2
    PLA Elegoo Yellow Transmission Distance: 5.6
    PLA Elegoo Orange Transmission Distance: 5.6
This print uses 5 unique filaments

!!!!  It is possible to print this hueforge with a single AMS unit just organize 
your filament swap in away that makes the most sense to you   !!!!!
 

Swap Instructions:
    Start with Black
    At layer #8 (0.72mm) swap to White
    At layer #11 (0.96mm) swap to Grey
    At layer #12 (1.04mm) swap to Black
    At layer #14 (1.2mm) swap to White
    At layer #15 (1.28mm) swap to Yellow
    At layer #18 (1.52mm) swap to Orange
    At layer #20 (1.68mm) swap to White for the rest.