This model is built based on the venue of the VEX PUSH BACK competition. However, since the actual venue has not been obtained yet, a 1:1 restoration cannot be guaranteed.

This component is a testing machine used to check whether the vehicle's chassis can pass through. As I used an A1 mini device for printing, I split the components into scattered parts and used multiple discrete connecting parts.

If you use other larger - sized printers that can print with a maximum side length of up to 20.08 inches (51 cm), you can directly use the complete connecting strip I provided. Theoretically, a 1:1 restoration of the original venue can be achieved (provided there are no manufacturing errors).

Note that the connecting strip is of a universal design, and only the channel part needs to be modified. It is recommended to use printing consumables with relatively high strength.

If you need a complete model similar to the above, you can print the channel part three times. However, due to the limitations of the A1 mini device, even if you do so, you can only get a similar model rather than an exact one, and I am unable to test the final result.