May have to adjust scaling a little to get it to click into your Multiboard. This is at 103% but adjust as needed. PLA works perfectly fine.

2-3 walls (both worked just fine for our use)

10-15% infill

Default standard supports (for snap portion)

Allows for vertical storage and use in your multiboard for the RC Hex Drivers with the back that can be screwed off allowing you to insert them into the pegs.

Set used in picture: [https://a.co/d/c54ETb4](https://a.co/d/c54ETb4) (non affiliate link)

Using commercial license account with [https://www.multiboard.io/](https://www.multiboard.io/) to create our own vertical storage option for hex and other opened-ended drivers of the same type. Other than the peg input, this is a completely custom design.