Hello! This model is a fast and funny print that can be enjoyed by anyone! For this model you need, Any nails that aren't any bigger than an inch, and some 6X2 or smaller magnets. It is very easy to assemble.

  First you need to glue the magnets at the bottom of the hole.(I used hot glue for mine😉) 

It don't matter which way you put the magnets in

they will always stick to the nails.

Once you do that, you have to put nails in the tree  That should look a little like this. Sorry for the blurry picture BTW.                                    

Then once you have the nails in sticking out about 1

Inch, than you can put the 3d printed parts on like this. 

Once your done you can turn the pieces upside down to make some hilarious looking faces!