Mouse Bait Station – Compatible with Pellets or Bait Blocks

This 3D-printed mouse bait station is designed to support both pellets and bait blocks up to 27mm x 37mm x 65mm. It works especially well with JT Eaton Bait Blocks.

Key Features:

• Sliding Lid – Easy to open and close for quick refills
• Pellet-Containing Lip – Helps keep loose bait contained
• Prevents Accidental Opening – Includes 3D-printed retaining pins for added safety

Instructions for Use:

1. Place bait block or pellets into the inner chamber.
2. Slide the lid on, starting from the side with the bait.
3. Insert the retaining clips and press them down until they snap into place.

Refill Instructions:

1. Insert a small screwdriver into the holes on the retaining clips and gently pry upward.
2. Repeat on the opposite side.
3. Slide the lid open.
4. Replace the bait.
5. Close the lid and reinsert the retaining clips.

Print Profiles Included:

This listing includes two print profiles:

• Single-Color Profile:
  Prints all components on a single build plate in one color.
• Multi-Color Profile:
  Includes:
  • One build plate with the retaining clips
  • Two additional build plates with lid variations:
    • One version uses layer-based color changes (ideal for printers without an AMS)
    • The other highlights only the labeling for a cleaner look

⚠️ Safety Disclaimer:

This bait station is intended for use in pest control and contains toxic substances. Keep out of reach of children, pets, and non-target animals. Always follow local regulations and manufacturer guidelines when handling rodenticides. Use only in areas inaccessible to unintended contact.