Fan project. Not officially licensed or affiliated with Warner Bros.

I've designed these cauldrons a couple of years ago and thought i could share them with you.

I used them for boardgames, to put the different chips, crystals… in them.

But they can also be used to put candy's and other stuff in them.

I printed them in Amazon Basics PETG, with tight supports to get the bottom a little cleaner.

The picture above, is from a reprint on my X1C, to check its printability.

The supports are really thight, so remove them with a dull knife. Put the knife in between the supports and the cauldron, and work your way around the support.

It should come off in one piece, like in my picture.

I've cranked up the “AUX Fan” on 100% and left the door closed, to get the Overhangs ass clean as possible. The overhangs were catastrophic without it, so i recommend you to do it and put the chamber fan on 60%.

The bottom will still be rough.

There are 8 models, 7 with logos from the different hogwarts houses… and 1 clean one without any logo.

I've only tested it on my X1C and on a Prusa MK3s, since i only had access to those.

Have fun

Edit:

I've added a new print profile for PLA-CF.
I used “Sunlu PLA-CF” for the print with Bambul Lab PLA-CF Settings.

I readjusted the Supports for this profile, making it a little easier for them to come of, but remember the Model will still be rough, where the support was.