This mod is ONLY for the 310 version of the BugBu. Just replace the same name parts from the BugBu 310 list with these parts to go tall. You will also need 2 - MGN12 linear rails for this mod. The linear rails will need to be 50mm shorter than the extrusions you are using for height. For example: If you order 4 - 500mm extrusions for the height, you would need 2 mgn12 at 450mm. You will also need to use more braces, and be sure your bug is secured to the table or bench it is on, is it will be top heavy with this mod.

Additional Parts Needed/Deleted from 310 BOM:

ADD - 2 EA: MGN12 linear rails. These will replace 2 linear rods, but you will still need 1 Linear rod the same length as your Z extrusions. The MGN12 will need to be 50mm Shorter as noted above

DELETE - 2 EA: Linear Rods for the Z and Linear Bearings for the Z

All other parts in the 310 BOM will remain the same.

All parts designed for 0.2mm layer height, 6 walls minimum, and 20% infill recommended for strength. These files are made for PLA, if using ABS or ASA bump size of parts up to 100.5% to account for shrinkage of materials.