Dyson Animal V11 Replacement Trigger

This might be useful if your Dyson v11 (and according to some websites, the Dyson v10 as well) has the following problems:

• It won't start and the battery is fully charged
• It won't stop after you release the trigger button
• The dyson pulse starts and stops even when the trigger remains pressed (and there are no problems with something clogging the cyclone, clogged filter etc )

I take no responsibility for any loss, harm or damage done whatsoever in any attempt to fix a dyson or replace. Definitely don't try it if your Dyson is under warranty. Plenty of guides out there on how to replace the trigger. You will also require 1 or 2 screwdrivers depending on where your model was made. You may be able to buy this piece online, but same as the developer, I was not keen to wait, and I also realised that I could probably buy another 1kg of translucent petg at the same price! 

Makerlab does not let me uploaad profiles using atypical filament settings. I believe the designer intended for the object and it's supports to be printed in PETG. The only change I made while printing this, is that I printed the object in translucent petg - on a smooth plate, and for the supports I used PLA as it was going to be easy to separate the two. If you don't use separate materials (PLA/soluble supports), then you might have to smoothen the holes - as this is what the developer recommended.  The smooth textured plate of course gives the surface a more finished look and feel.