Hi everyone! I'm proud of this as my first official Lightbox that I feel is more than just a “Lightbox.” This Sleepy Time Sloth Lightbox is a vibe all in itself, and it's the least energetic vibe that could be had. I hope you love the design and would love your feedback about anything that you think could have been done better or just differently!

--------------------

PRINT INFORMATION (TESTED)

• Layer Height: 0.16 mm
• Wall Loops: 2
• Infill: 10% (Honeycomb)
• Bottom & Top Surface Pattern: Monotonic
• Print Time: 5H 25M (Bambu A1)
• Filament Usage: 144.91g (5.71g of waste).
• Initial Layers Speed: 25 mm/s

--------------------

FILAMENT & PARTS

Filament is pretty flexible for these, but the lighter the color, the better when working with lightboxes. Don't be afraid to experiment. I used Elegoo colors for this model.

You will need an LED light strip for this. You can use Bambus, but I prefer the “onn." brand, often found at big box retailers. 10 10-foot strands are typically $5 USD - $6 USD and emit enough light to fill the box out nicely.

IMPORTANT POST PRINT INFORMATION

• Accommodates roughly 3 to 5 feet (1 to 1.5 meters) of LED lights.
• Place lights ⅔ of the depth of the box so the light has space to diffuse for a “full” effect.
• Suggested to put LEDs on the sides of the “Front Cover" and not on the “Back Cover"

--------------------

COOLDOWN WARNING

With any lightbox models, it is highly suggested not to remove them from the build plate until the part has cooled down sufficiently. Due to the thinness of these prints, they can easily warp if removed too hot and cannot be fixed.

--------------------

COMMERICAL SELLING

I keep this simple. All I ask is that you subscribe to my Patreon and sell these commercially. You cannot edit my digital files, but color swaps, of course, are welcome. 

Powered by Lightbox Maker from MakerWorld (https://makerworld.com/makerlab/lightboxMaker)