A compact dock for the Nintendo Switch 2 that you can actually fit in your pocket.

Disclaimer: You are fully accountable for any damage that may occur while building this. This project requires disassembling the original Nintendo Switch 2 dock.

Required Parts from Original Dock

Components to Acquire:

• Motherboard
• USB-C connector (with ribbon cable
• Top cover of the motherboard (the one with the thermal pads)
• Status LED

Screws to Acquire:

• 6x black screws holding down the motherboard
• 2x black screws holding the USB-C connector
• 1x silver screw holding the status LED

Assembly Guide

1. Gut the Switch 2 dock. Remove all components and screws listed above. 
2. Install the status LED. Screw it in with the ribbon cable pointing to the corner of the dock. It is recommended to first remove the LED from the motherboard and reattach it after it is secured in the new dock.
3. Insert the motherboard. Use the 3 alignment pins for correct placement.
4. Secure the motherboard. Use 2 screws. Ensure no screw holes that pass through to the bottom are covered.
5. Secure the USB-C holder. Use 2 screws to fixate the USB-C holder to the lid.
6. Close the dock. Bend the ribbon cable slightly to fit it into place. Do not force anything.
7. Attach the bottom lid. Screw in the lid from the bottom of the dock using the remaining 4 screws.