Here's a little flamey cave gecko I made a year or so ago and had stored away in my files (and in a pile of old prints!). I thought you might all like it, so I am sharing it with you! I made some modifications before posting it, so it shouldn't have any issues despite being a li'l ancient.

As a warning, as this is an old model being posted for free (and does not reflect the quality of my new, paid models), I will not be updating it ✨, but it should still be an easy print for a calibrated Bambu 😊✨💖

Recommended Print Settings:

• Layer Height: .16
• Infill: 15%
• Supports: Not needed
• Adaptive Layer Height recommended (but will slow print down)
• Slow down first five layers
• Pro Tip: If the first layers struggle to stick, try slowing down your first layers or increasing the bed temp slightly.
• Tested to 70%

Please be warned that these models are not recommended to be printed for young children, or anyone at risk of a choking hazard. There are small parts that can be broken off if roughly handled. Print at your own risk!

------------------------------------------

If you like this design, please check out my other models: [https://cults3d.com/en/users/](https://cults3d.com/en/users/)StarMouse3D/creations

StarMouse3D creations are protected by copyright. These files are for personal use only, and you do not have the right to sell the files or the models without explicit consent from me.
 

To legally obtain permission to sell PHYSICAL prints you may obtain permission to sell every model as an active Patreon supporter through this link: [https://www.patreon.com/c/](https://www.patreon.com/c/)StarMouse3D

Please do not share digital files! Thank you.